8.7 C
New York
Thursday, November 26, 2020
Home Staad Pro

Staad Pro

Design of Pile Cap Using Staad Foundation Advanced

Pile caps are rigid plate structures that are used to transfer superstructure load from columns to a group of piles. They are usually subjected...

Effects of Wind on Different Configurations of Masts

Telecommunication masts or towers are tall structures that are designed for transmission of telecommunication signals or for radio/television broadcasting. Telecom masts are usually made...

Analysis and Design of Arch Bridges

The use of arches as a structural form can be dated back to antiquity. Arch structures are unique structural forms which resists forces majorly...

Analysis of Moving Load on Cable-Stayed Bridges Using Staad Pro

Stays can be used to support orthotropic bridge decks which consists of continuous girders. The stays which are inclined cables passing over or pinned...

Design of Pile Foundation System for Bridge Piers

Piles are the most preferred type of foundation for supporting the piers of overhead bridges. They offer greater resistance to vertical and horizontal actions...

Design of Bridge Pier and Pier Cap

Bridge pier caps are horizontal structural members used for transferring bridge deck loads to the piers, before they are transferred to the foundation. They...

How to Offset Beams in Staad Pro (with video tutorials)

In some cases, structural members are not perfectly connected to each other along their centroidal axis. This can be as a result of structural...

Non-linear Analysis of Cable Stayed Structures on Staad Pro

Non-linear analysis can be used when all of the members, elements and support springs are linear except for cables and/or preloaded truss members. This...

New Textbook: Modelling, Analysis, and Design of Overhead Steel Tank Supports

This book has been written to address an area of structural design which is usually neglected by clients, architects, and home owners. During the...

Analysis and design of counterfort retaining walls using Staad Pro

Retaining walls are structures used for supporting earth at different levels. There are different types of retaining walls such as cantilever retaining walls, gravity...

Load Transfer from Slab to Beams – A Comparative Analysis

In the design of reinforced concrete structures, floor loads are usually transferred from slabs to beams, and from the beams, the loads are transferred...

Natural Frequency Analysis of Multistorey Frames Using Staad Pro

https://youtu.be/dqxGIy9fcvo Vibration (or Oscillation) is a time-dependent, repeated motion which a body undergoes when it is excited in its natural state or by an external...

Most Read

Guidelines for Tying of Reinforcement

In the construction of reinforced concrete structures, reinforcement bars must be tied together in order to hold them in place and to also facilitate...

Cost of Reinforcement Works in Nigeria

Installation of reinforcements is an important item of work in the construction of reinforced concrete structures. The cost of reinforcement works therefore significantly impacts...

Design of Shear Walls

Shear walls are structural members that provide additional lateral stiffness to a building by resisting shear, moment, and axial forces, which are produced due...

Technical Guide: Detailing and Arrangement of Beam Reinforcements on Site

Beams are horizontal structural elements used for supporting lateral loads. In conventional reinforced concrete structures, beams usually receive load from the floor slab, but...
error: