8.7 C
New York
Thursday, November 26, 2020
Home Trusses

Trusses

Simplified Design of Welded Connection to Eurocode 3

In our previous post, we were able to present an example on the design of fillet welds for truss members using two different approaches....

Strength of Spaghetti Bridge Trusses (Video)

Interestingly, uncooked spaghetti has been used extensively to demonstrate the behavior of structures under the action of externally applied loads. Investigations have usually included; (1)...

Flexural Buckling of Columns

When structural members are subjected to compressive forces, the members may fail before the compressive resistance (A.fy) is reached. This premature failure is usually...

Design of Timber Roof Truss to British Code: Solved Example

The use of timber as trussed rafters for roof of buildings is a very popular alternative all over the world. The aim of this...

Member Design of a 22m Span Steel Roof Truss

Introduction We all need a roof over our head. Nowadays, architects frequently use roof pattern and design to enhance the aesthetics and functionality of a...

Structural Design of Pile Caps Using Strut and Tie Model (EC 2)

Pile caps are concrete mats that rests on piles with adequate rigidity to transfer the column loads to the piles. Piles are provided as...

Analysis of Statically Indeterminate Truss Using Force Method: Solved Example

Introduction Indeterminate trusses are analysed usually analysed using force method or direct stiffness method. In this post, we are going to analyse step by step,...

How to Design Fillet Weld connection for Steel Trusses (EC3)

In modern construction, the commonest methods of connecting steel members are by bolting and welding. Eurocode 3 identifies different types of welding such as; ...

Analysis of Trusses Using Direct Stiffness Method: A Solved Example

An indeterminate truss is supported and loaded as shown above, using the direct stiffness method, obtain the displacements, support reactions, and internal forces that...

Free Vibration of Trusses: A solved Example

Dynamics of structures is a special branch of structural analysis, which deals with the behaviour of structures subjected to dynamic loads (loads that vary...

Most Read

Guidelines for Tying of Reinforcement

In the construction of reinforced concrete structures, reinforcement bars must be tied together in order to hold them in place and to also facilitate...

Cost of Reinforcement Works in Nigeria

Installation of reinforcements is an important item of work in the construction of reinforced concrete structures. The cost of reinforcement works therefore significantly impacts...

Design of Shear Walls

Shear walls are structural members that provide additional lateral stiffness to a building by resisting shear, moment, and axial forces, which are produced due...

Technical Guide: Detailing and Arrangement of Beam Reinforcements on Site

Beams are horizontal structural elements used for supporting lateral loads. In conventional reinforced concrete structures, beams usually receive load from the floor slab, but...
error: